When you open the package, you will find:

– 1 sheWim® LED face mask

– 1 sheWim® LED neck mask

– 1 rechargeable remote control (built-in battery)

– 2 silicone eye protectors (to attach to the face mask)

– 1 user manual

The battery is located inside the remote control, not in the mask.

The mask only works when connected to the remote.

The remote control acts as both:

– the power source

– the control center (on/off, intensity, LED modes)

The remote comes partially charged.

For the first use:

– Charge for about 20 minutes

– Charging is complete when the indicator lights stop blinking and remain solid

For a full charge later (battery fully empty):

– Total charging time: approximately 3 hours

No. The mask does not operate while the remote control is connected to power.

Always unplug the remote control before using the mask.

– To turn on: press and hold the right button on the remote for 3 seconds

– To turn off: press and hold the same button for 3 seconds

Once the mask is turned on:

– Use the left button

– Press repeatedly to increase or decrease intensity

– There are 5 intensity levels

– Use the right button

– Press repeatedly to cycle through the 7 LED modes

Always start with clean skin:

– Cleanse face and neck

– Gently pat dry

Then apply:

– Face serum on the face

– Neck cream on the neck

Apply a thin layer.

Skin should be hydrated, not greasy.

– Apply skincare first

– Put on the face and neck masks

– Adjust comfortably

– Then turn on the remote and select your settings

Settings should always be adjusted after the mask is worn.

Each session lasts about 10 minutes.

At the end of the session, the mask turns off automatically.

This is a built-in safety feature.

You may restart a new session if desired.

The mask is equipped with an intelligent safety system:

– Each session is intentionally limited to 10 minutes

– Prevents overexposure

– Protects the skin

– Preserves battery life

This system ensures safe, controlled, premium at-home use.

A full charge provides approximately 120 minutes of total usage.

Battery life may vary depending on:

– Selected LED mode

– Chosen intensity level

Red Light – 630 nm

Use: Anti-aging & firmness

Stimulates skin renewal and improves elasticity

Recommended for wrinkles, sagging, and anti-aging prevention

Blue Light – 460 nm

Use: Breakouts & excess oil

Helps reduce bacteria associated with blemishes

Recommended for oily and acne-prone skin

Green Light – 520 nm

Use: Uneven skin tone

Helps balance the skin and improve tone uniformity

Recommended for dark spots and dull complexion

Yellow Light – 590 nm

Use: Soothing & radiance

Helps calm redness and revive skin glow

Recommended for sensitive and tired skin

Purple Light – 630 + 460 nm

Use: Blemishes & regeneration

Combines red and blue light benefits

Recommended for blemish-prone skin with marks

Cyan Light – 520 + 460 nm

Use: Unbalanced skin

Helps refresh the skin and improve overall clarity

Recommended for combination and stressed skin

Infrared Light – 850 nm

Use: Deep care & comfort

Works beneath the skin surface to support comfort and recovery

Recommended for sensitive skin and gentle care

Always start with a low intensity.

Levels 2–3:

– Sensitive skin

– First-time use

Levels 4–5:

– Normal skin

– Regular use

If you experience excessive warmth or discomfort, reduce the intensity or stop the session.

For best results, use the mask 3 to 5 times per week.

Experienced users may use it up to once daily, as long as sessions remain short and skin comfort is respected.

Standard use:

– 1 session of 10 minutes

Experienced users:

– 2 sessions of 10 minutes

Maximum recommended:

– 3 sessions of 10 minutes, with a short break between sessions

More sessions are not necessary to achieve results.

Regular use is more effective than prolonged use.

No. The sheWim® LED mask is EMS-free and micro-current-free.

It is non-invasive and designed for cosmetic at-home use.

– Clean after each use

– Use a soft, dry cloth

– If needed, a slightly damp cloth

– Never immerse the mask in water

– Do not use alcohol or abrasive products

– Dry completely before storing

The remote control should be cleaned dry only.

– Fully charge before first use

– Avoid letting the battery reach 0% too often

– Recharge as soon as battery is low

– Do not leave plugged in unnecessarily after full charge

– Allow a few minutes between sessions

– Store in a dry place at room temperature

– Avoid excessive heat and humidity

– Apply skincare before the mask

– Put on the mask before turning it on

– Adjust settings once the mask is worn

– No EMS, non-invasive

– Short, regular, and safe use